PLANT CLONER HACK WITH PENS – AIR STONE HACK FOR GROWING CUTTINGS

This Article is an update to my previous article on the DIY air bubble plant cloning device we built step by step the other day. This plant cloner which works on the principle of oxygenation and hence useful for faster rooting or faster growing of plant cuttings with good success rate.

If you haven’t watched that yet, please check HERE.

This simple Hack am showing you today will actually overcome one limitation of using air stones or other similar bubblers, That is they get clogged easily, specially if they are of low quality. After watching this hack, you may not feel like purchasing air stones at all. Yes, this is a permanent solution to this drawback of using air stones or similar stuff.

What you can do is: Just take two Ball pens like these. These are the famous Reynolds pens. Am sure all of us know about these pens.

Remove the refills and make tiny holes into the white plastic body by heating a needle. Make tiny holes as many as you want.

Then connect the air tube to the open end of the pens and place them into your cloning chamber. That’s it.

You can see how nicely and uniformly the bubbles are appearing. Also one more point and update is:  you need not keep the bubbler continuously switched on. You can switch it on and off intermittently or atleast for 10 minutes 2 or 3 times in a day to get best results.

Also if you have a PH testing gadget, try to maintain the ph of the rooting solution or water to a slightly acidic ph of around 6.0 for best results.

 

Content Protection by DMCA.com

About admin

Check Also

10 Bonsai Hacks That Save Money & Time – Making Bonsai Trees Quickly

Whether you are a bonsai expert or a beginner just thinking to start making some …

Leave a Reply

Your email address will not be published. Required fields are marked *